Perle eX-1C110-RJ - Short-haul modem - 100Mb LAN, Ethernet over VDSL2 - 10Base-T, 100Base-TX - RJ-45 / RJ-45 - up to 1.9 miles
- Extend Ethernet over coaxial cable
- Hi-speed performance
- Plug and Play operation
- Link pass-through
- Interlink fault feedback
- Auto-negotiation
- Auto-MDIX
- Fixed speed and duplex
The simple and effective point to point Ethernet Copper Extender is perfect for commercial buildings, residential units, hospitality environments, connecting a remote office or private-network backbone to a corporate LAN anywhere you need Ethernet communication links between separated LANs or LAN devices.
Perle's advanced features such as link pass-through, interlink fault feedback, and loopback allow network administrators to "see everything" for more efficient troubleshooting and less on-site maintenance.
-
Plug and Play operation
Perle Ethernet Extenders will automatically configure your VDSL interlink connection. The CO/CPE peer association will be determined automatically by the Ethernet Extender. No need to set CO/CPE VDSL pairing. Once a connection is made, both ends will automatically adjust relevant VDSL parameters to optimize the level of bandwidth possible across the copper link.
-
Link pass-through
With link pass-through the state of the 10/100/1000Base-T Ethernet connection is "passed through" the VDSL link to the 10/100/1000Base-T Ethernet connection on its remote peer. A managed switch on the remote end can then report the state (link up or link down) to its network management system so that any errors can be detected and recovered early.
-
Interlink fault feedback
Similar to the link pass-through feature, a loss of VDSL link will drop the 10/100/1000 Ethernet ports on each end until the link recovers.
-
Auto-negotiation
The Ethernet extender supports auto negotiation on the 10/100/1000Base-T interface.
-
Auto-MDIX
Auto-MDIX (Automatic Medium-Dependent Interface crossover) detects the signaling on the 10/100/1000 Ethernet RJ45 interface and determines the type of cable connected (straight-through or crossover) and automatically adopts a compatible pinout.
-
Fixed speed and duplex
Some Ethernet equipment require a fixed speed and duplex be used or cannot auto-negotiate. By disabling auto-negotiation on the Ethernet extender, a fixed speed of 10,100 or 1000 Mbps as well as full or half duplex can be configured through DIP switches.
